Matters needing attention during trial operation of worm gear reducer

Worm gear reducerNo-load trial operation is required after installation. This is an indispensable step, and the time is about 2 hours.When the worm gear reducer is running for about 2 hours, it can be loaded and tested step by step at 25%, 50%, and 75% load until it runs at full load.

After the load test of the reducer is completed for a period of time, it is necessary to carefully check whether the fasteners of the machine are loosened to ensure the safe carrying.Pay attention to the noise and heat dissipation of the reducer during the trial load.

Check the oil and lubricating oil usage of the reducer:
1,Worm gear reducerCheck the lubricating oil level and block its power supply to avoid electric shock and wait for the reducer to cool down.
2. Remove the oil level screw plug to check whether the oil is overfilled, and install the oil level screw plug after checking.
3. Open the oil drain plug, take out the lubricant sample, and check the viscosity index of the lubricant.If the lubricating oil is significantly dirty, it is recommended to replace the lubricating oil as soon as possible.
4. Regarding the worm gear reducer equipped with an oil level plug, unscrew the oil level plug, check the refueling height, and add lubricating oil when necessary.
5. The replacement of lubricating oil, the viscosity of the oil increases after cooling, and it is difficult to drain the oil, so the worm gear reducer should be changed at the operating temperature.

The above is about the matters needing attention in the trial operation of the worm gear reducer. Do every step of the operation to ensure the quality and safe use of the reducer.