The stepless speed changer needs to pay attention to when installing
1. When installing the base-type continuously variable transmission on the foundation, the installation centerline elevation, levelness and related dimensions of the associated parts should be calibrated, and the coaxiality of the calibrated drive shaft should not exceed the allowable range of the coupling.
2. When installing couplings, pulleys, sprockets, etc. on the output shaft, do not hit hard.Use the screw hole at the outer end of the output shaft, screw in the screw, and press into the coupling.
3. The vertical MB stepless speed changer can be installed at any angle, and the oil level must exceed the center line of the oil mark on the higher side.
Previous:The performance characteristics of RV worm gear reducer are marked into the code method
Next:Matters needing attention during trial operation of worm gear reducer
Article Source:
Back to list- What kind of equipment is the ring-cone differential planetary continuously variable transmission?
- What are the characteristics of UDL coaxial continuously variable transmission
- Application and characteristics of JWB-X series stepless speed changer
- JWB-X series stepless speed changer first and second level parameters and size table
- Model representation method of JWB-X series stepless speed changer
- Horizontal and vertical installation dimensions of MB series continuously variable transmission
- Code writing and using parameters of MB series continuously variable transmission
- Basic structure diagram and brief introduction of MB continuously variable transmission
- Product Features and Product Marking of Continuously Variable Transmission
- The stepless speed changer needs to pay attention to when installing